1960's G.E. Trimline 500 SS Stereo

Discussions about instruments in smaller cabinets. If they don't set on the floor, they belong here. Tube and solid state, stereo and mono.
Post Reply
User avatar
Hi-Fi-Mogul
Anchor Member
Posts: 1369
Joined: Sat Jul 10, 2021 1:53 am
Contact:

1960's G.E. Trimline 500 SS Stereo

Post: # 31096Post Hi-Fi-Mogul »

Finished this up today for a customer who had brought it
by from 50 miles away !

The amplifier controls were very dirty and mostly non-functional.

To access the solid state amp, remove the chrome controls panel,
then the larger rear cover panel which sits in two clips.

Then there are 2 more screws to release the amplifier.

I was able to get enough cleaner into the 4 pots without
dis-connecting all the amp wiring.

Next, the changer needed basic cleaning of the motor
board speed controls, motor cleaning, new motor mounts,
record spindle thrust washers, platter bearing race,
and some cleaning of cycling mech.

The tonearm required set-down and end of record actuator adjustments.

The original idler wheel works well after cleaning.

,
,
Attachments
Trimline 500 G.E. SS.JPG
G.E. Trimline 500 Motor Board-A.JPG
G.E. Trimline 500-1A.JPG
G.E. Trimline 500 -2A.JPG
Hi-Fi-Mogul
User avatar
William
Global Moderator
Posts: 5519
Joined: Fri Jul 09, 2021 12:42 pm
Location: Hart, Michigan
Contact:

Re: 1960's G.E. Trimline 500 SS Stereo

Post: # 31097Post William »

Those are nice units, I have the tube version with the V-M changer with the wide tone arm. Not sure how the SS one sounds but the tube on sounds pretty good. Nice job, Mr. Mogul.

Bill
User avatar
Hi-Fi-Mogul
Anchor Member
Posts: 1369
Joined: Sat Jul 10, 2021 1:53 am
Contact:

Re: 1960's G.E. Trimline 500 SS Stereo

Post: # 31098Post Hi-Fi-Mogul »

Bill, this G.E. has incredibly good sound.

And being SS, no extraneous hum ! [ : )

I had never serviced one, but now I'll be up to speed if
I receive another.
Hi-Fi-Mogul
User avatar
electra225
Site Admin
Posts: 9077
Joined: Thu Jul 08, 2021 7:48 pm
Location: San Tan Valley, AZ
Contact:

Re: 1960's G.E. Trimline 500 SS Stereo

Post: # 31108Post electra225 »

My neighbor lady has one of those. Runs the wheels off it. Tough machine. The tube ones sound like the solid state ones for the most part. The higher-end models don't have the hum you talk about. I have one of the cheap ones and it had a little hum. We talked about it here on the forum, so I started tinkering. I increased the output filter cap to 100uf and the hum went away. The tube ones need a lot of filtering. The power transformer models don't seem so prone to hum. The 500 is the next to the top of the line. They made a 600 which had an AM=FM radio and a more upscale changer. The solid state models used a GE changer, the tube ones used VM and Garrard.
I haven't failed. I've just found 10,000 ways that won't work.....Thomas Alva Edison
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests